Using Data Terminal in Logic with a PK 232 - All Other

Welcome Guest! To enable all features please Login or Register.

Notification

Error

LOGic Forum » LOGic Support » All Other » Using Data Terminal in Logic with a PK 232

Using Data Terminal in Logic with a PK 232

Options View

Previous Topic Next Topic

N3HR		#1 Posted : Sunday, June 10, 2018 11:31:58 AM(UTC)
Rank: Member Groups: Registered Posts: 16 Location: Mechanicsburg, PA Thanks: 9 times Was thanked: 1 time(s) in 1 post(s)		I'm trying to setup my PK 232 with Logic. I am looking for the correct settings i.e. Baud Rate, Data Bits Stop Bits, Parity, Handshaking. Thank you.
Back to top

User Profile View All Posts by User View Thanks
Sponsor
Note: We receive a commission from Amazon when you purchase via this link. It does not affect your cost. Thank you!
Back to top

WN4AZY		#2 Posted : Sunday, June 10, 2018 1:52:49 PM(UTC)
Rank: Administration Groups: Administrators, Beta Testers Posts: 3,097 Location: Auburn, GA Thanks: 998 times Was thanked: 497 time(s) in 412 post(s)		Hi-- The settings in LOGic are in tools/setup/misc ham setup. As for what they should be set to, set them to match the PK-232. I am referring to the baud rate etc used to communicate with the PK-232, not the baud rate used by over-the-air data communications. Consult the PK-232 manual. This may be the right one: http://www.repeater-buil...bx-operating-manual.pdf Tnx & 73, Dennis WN4AZY
Back to top		WWW \| Edit by user

User Profile View All Posts by User View Thanks

Users browsing this topic
Guest

LOGic Forum » LOGic Support » All Other » Using Data Terminal in Logic with a PK 232

Forum Jump

You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.